Ruffle Strap Dress pattern, Moda, Wykroje krawieckie

[ Pobierz całość w formacie PDF ]
M
aking the pattern block for Recycled Ruffle Strap Dress
………………………………………………………………………………………………
Here is how I approached the construction of the pattern block required for my Recycled
Curtain Ruffle Strap Dress. I already had the bodice block done up prior to this project,
which I had been using to make multiple outfits.
I used a CAD program to draw up the block so it was a lot easier, so if you know how to
use a CAD program then I would definitely recommend it. Plus you can just print out to
scale, which is quite handy!
I have had no formal training for pattern-making or even in general sewing, so please
excuse any wrong terminology or if there are better and easier ways for some steps, and I
would love some feedback. Minor tweaking was required after I made this block, but
nothing major should be needed.
Anyways, here goes!
Make note of the dimensions needed. All measurements are horizontal or vertical
with no funny angles, though the image can be a little confusing.
Now, unless you are as light as I am around the chest region, I would recommend
that you wear a bra when taking measurements.
You will need:
•
Chest measurement – I measured just above the nipples
•
Under bust chest measurement
•
Waist measurement – Smallest part of your torso
•
Waist to top of bra line on the side seams – Name it SIDE SEAM
•
between P1(top of bra line) to P2 – Name it B-TOP
•
between P2 and P3(to the centreline) – Name it B-INNER
•
between P2 and P5 – Name it B-OUTER
•
between P2 and P4 – Name it B-UNDER
•
between P4 and centreline Name it B-FRONT-W
•
between P3 and waist level – name it B-FRONT-H
•
between P4 and waist level – Name it W-FRONT SEAM
•
waist to skirt hemline
1.
1.
Make a point on the upper left corner of the page. Mark this point A. From there,
draw a downwards line the distance of B-TOP. Mark this point B.
2.
From point B, draw a horizontal line across the distance of half the chest
measurement plus 2m. Name this point C.
3.
From point C, draw a line straight up, the distance of A to B.
Mark this point D. Join A to D.
4.
From point B, mark the distance of B-INNER, towards point C. From point C
towards point B, mark the distance of B-OUTER. Find the midpoint between the
two points and Draw a line up to line A-B. Name the top point ET, and the bottom
EB.
5.
Mark a spot from B towards A, the distance of 1/4 of A-B, and name F. From this
point, create a very slightly curved line to EB. Mark a point from C towards D,
the distance of 1/8 of the D-C line and name the point as G. Make a note of the
measurements F-B and G-C, as you will need it later.
6.
From ET, mark towards point D, the distance of 1/8 of ET-D. Name this point H.
7.
Measure 15mm up from F and name I. Measure 20mm up from G and name J.
8.
Create the top of the bust by joining H to I, and H to J with shallow curves.
These lines can be tweaked later, according to preference of the shape.
9.
You can now remove the rest of the lines to form the block for the top of the bust.
[ Pobierz całość w formacie PDF ]

Ruffle Strap Dress pattern, Moda, Wykroje krawieckie

Tematy